Ticket #1807627

Hello all, I have some pads that are being extracted incorrectly during the “Test Results” process. However, they get extracted correctly on the board when teaching the component. All of them are related only to resistor arrays. [image.png] [image.png] I went ahead and adjusted the pads for all the res array components, they look great on the board. However, during test I always get this odd extraction as shown above. Here is the pad extraction color, as you can see, it’s quite well defined: [image.png] Any explanation to why this is happening? Best regards, Imad Messelmani [email] Process & Software Engineer Phone: ([phone] ext. 327 [email] www.maksinc.net | [email] LinkedIn This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error please notify the system manager. This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. If you are not the intended recipient you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this information is strictly prohibited.